HURRICANE Intensive Stone Cleaner is a highly active, extra-strength degreaser, cleaner, and grout film remover that is safe for use on:

• natural stone
• terrazzo
• agglomerate
• ceramic
• porcelain tiles

Effectively removes dirt deposits, grease accumulation, food stains, and petroleum-borne soils without affecting the natural structure of the stone.

HURRICANE intensive stone cleaner is intended for use as a periodic cleaner where heavy soiling is present, for construction job site clean-up and as an integral part of the STONE CARE SOLUTIONS Maintenance System. HURRICANE is safe to use on:

• granite
• marble
• polished limestone
• terrazzo
• flagstone
• clay tile
• terra cotta
• quarry tile
• cantera
• ceramic tile
• porcelain
• slate
• pavers
• grout
• concrete
• masonry.

DIRECTIONS

For soil removal, job site clean-up, and /or grout film removal:
1 part of Hurricane 8-10 parts of warm water for light soil removal.
1 part of Hurricane 4-7 parts of warm water for moderate soil removal.
1 part of Hurricane 2-3 parts of warm water for heavy soil removal.

For periodic intensive cleaning:
1 part of HURRICANE 12 parts of cool or warm water for light soil removal .
After diluting the chemical, apply the solution to the surface using a mop, sponge, or sprayer and agitate briskly with a mop or scrub brush.
Allow to dwell for 10 minutes; vacuum and rinse well with clean water and vacuum again.

The post Hurricane Intensive Stone Cleaner appeared first on Kong Restoration Depot.

Tile & Stone Cleaner 1gal  is a pH neutral cleaner designed for all tile, stone, grout and masonry surfaces. This cleanser is strong enough for the professional, yet gentle enough for the do-it-yourself specialist. Tile & Stone Cleaner is a non-toxic cleaner that can handle the most difficult stains, yet is gentle enough for everyday use. It comes in both a ready-to-use spray and a concentrate for diluting options.

The post Tile & Stone Cleaner (Mira Clean #1) appeared first on Kong Restoration Depot.

Bare Bones Stripper is  55% active speed stripper that easily cuts through multi-layers of burnished floor finish. This “true” no-rinse stripper does not contain potassium hydroxide or sodium hydroxide yet is the fastest working liquefier on the market. Low foaming, no scrub, and no-rinse features make this product a must for all professional floor care systems.

• DIRECTIONS

1. 1. Dilute BARE BONES® following dilution recommendations below. Dilute using cold or mildly warm water only.
   2. Light/Normal Buildup: 8 oz per gallon of water (1:16)
   3. Heavy Buildup (Burnished): 20 oz per gallon of water (1:5)
      1. Mop/Wet Vacuum Stripping System:
         Apply liberally with a mop to an area small enough so as not to allow the product to dry and allow to stand for 3 to 5 minutes.
         Agitate with a mop and remove the solution and old finish with a wet vacuum.
         Allow the floor to dry thoroughly and apply a new finish as directed by the manufacturer.
         If complete stripping is not accomplished repeat the above procedure before re-application of recommended NCL Floor Finish.
      2. Floor Machine Stripping System: Allow to stand for 3 to 5 minutes, scrub with a rotary floor machine or automatic scrubber equipped with stripping pads.
         Remove the solution and old finish with a wet vacuum and allow the floor to dry completely.
         If desired, a rinsing step can be added. Apply recommended NCL Floor Finish as per instructions.

Note: Asphalt tile, Linoleum, and other sensitive floor surfaces may be damaged by contact with a stripping solution.
We recommend that a spot test be conducted before general use.

• TDS
• SDS

The post Bare Bones Floor Stripper 1 GAL appeared first on Kong Restoration Depot.